Coupons

$49.50 Heating Check-Up

Freon Check & Charge for $69.00. Includes up to 2lbs of freon. J.R. Putman purchased 750lbs of freon before the price doubled.Once the freon is gone so is this special.

J.R. Putman, Inc. will do a complete and thorough check of your unit which will include the following on your cooling unit: 

   1. Calibrate thermostat
   2. Evaluate freon charge
   3. Flush outdoor coil(when accessible)
   4. Tighten all high and low voltage  connections(where accessible)
   5. Inspect air ducts
   6. Measure air temperatures
   7.Measure for correct air flow
   8.Measure power usage on all motors
   9.Test all capacitors
  10.Perform safety check
  11.Measure starting capabilities
  12.  Check safety controls
  13. Minor condensate flush
  14. Meg ohm the compressor
  15. Inspect and tighten screws on contactor
  16.  Inspect unit for proper refrigerant level and adjust if necessary
  17.  Clean dirt, leaves and debris from inside cabinet
  18.  Inspect base pan for restricted drain openings—remove obstructions as necessary
  19.  Inspect coil and cabinet
  20.  Inspect fan motor and fan blades for wear and damage—on older models lubricate as needed
  21.  Inspect control box, associated controls/accessories, wiring and connections. Controls may include contactors, relays, circuit boards, capacitors, sump heat and other accessories. All control box and electrical parts should be checked for wear or damage.
  22.   Inspect compressor and associated tubing for damage
  23.   Inspect  blower assembly (includes blower housing, blower wheel and motor)
  24.   On older models, lubricate motor and inspect and replace fan belt if needed
  25.  Inspect evaporator coil, drain pan and condensate drain lines.
  26.  Clean or replace air filters(owner supplied if throwaway type)
  27.  Inspect conditioned airflow system (ductwork)—check for leaks
  28.  Monitor system starting characteristics and capabilities
  29.  Listen for abnormal noise
  30.  Search for source of unusual odors
  31.  Monitor air conditioning and heat pump systems for correct refrigerant charge
  32.  Measure outdoor dry bulb temperature
  33.  Measure indoor dry and wet bulb temperature
  34.  Measure high and low side system pressures
  35.  Check vent system for proper operation
  36.  Monitor system for correct line and load volts/amps
    Monitor system operation per manufacturer's specifications
  37.  Provide system operation report and recommend repairs or replacement as necessary

Purchase one of our duct cleaning packages and receive 10% off of the regular price!